Is there a way to prevent the tabs from changing order?
I usually setup my workspace, with specific files in the first tabs (e.g., spec/test on cmd-1 and code on cmd-2). It seems that every once in awhile it changes the order. Can I get TM2 to leave the tab order alone?
On 26/01/2012, at 04.07, Darren Boyd wrote:
I usually setup my workspace, with specific files in the first tabs (e.g., spec/test on cmd-1 and code on cmd-2). It seems that every once in awhile it changes the order. Can I get TM2 to leave the tab order alone?
When you open a file it always opens to the right of the current tab so that ⌘W goes back to the one you were working in. This happens even if the file is already open, unless you switch with ⌘1-n.
There are no settings to change this behavior.
On Jan 31, 2012, at 1:59 AM, Allan Odgaard wrote:
On 26/01/2012, at 04.07, Darren Boyd wrote:
I usually setup my workspace, with specific files in the first tabs (e.g., spec/test on cmd-1 and code on cmd-2). It seems that every once in awhile it changes the order. Can I get TM2 to leave the tab order alone?
When you open a file it always opens to the right of the current tab so that ⌘W goes back to the one you were working in. This happens even if the file is already open, unless you switch with ⌘1-n.
There are no settings to change this behavior.
While that sounds like a perfectly valid reason, I care much less about what file I end up in after a ⌘W than what files are displayed in the first tabs.
So let me add a "me too" requesting a setting that causes new tabs to be added "at the end".
Thanks
Gerd
-
Allan Odgaard -
Darren Boyd -
Gerd Knops