As far as I can tell, this has more to do with how bad beamer is at reporting errors. In my experience, debugging errors in beamer using the latex log file can be, in the best case, only slightly easier than with the bundle's compile log. I really don't think there's much that can be done in the LaTeX bundle, but I might be wrong.

enas

On 9 Nov 2012, at 18:40, Bart Vandereycken wrote:

Hi,

I was wondering whether it would be possible to include some more info when latex complains about errors. The main point is that the line number that latex gives you (and what is displayed in the Textmate error window) can sometimes be way off, especially when you have a lot of code and the error is many lines above this line.

For example, if I compile the following beamer document

---

\documentclass{beamer} \begin{document} \begin{frame}

a

b

c

\unknown

d

e \end{frame} \end{document}

---

then Textmate tells me

---

Latex Error: ./test.tex:17 Undefined control sequence.

which corresponds to "\end{frame} ". The error is obviously in line 12 because of the unkown command \unknown.

It is not hard to see that when you have a lot of complicated math, tracking down a single typo can sometimes be very painful...

I realize that getting the exact line number for such an error is difficult, but since the latex log already indicates that \unknown is unknown,

---

... ./test.tex:17: Undefined control sequence. \beamer@doifinframe ...par b \par c \par \unknown \par d \par e \end {beamer... l.17 \end{frame}

---

it would make life a lot easier if this is visible in the log window of Textmate too.

So, would it be possible to include, for example, these last two lines in the Textmate error window too?

---

textmate mailing list textmate@lists.macromates.com http://lists.macromates.com/listinfo/textmate